crwdns2915892:0crwdne2915892:0
In this guide you will be removing the back panel and motherboard to access and remove the inside keyboard.
crwdns2942213:0crwdne2942213:0
-
-
Place the phone face down on the table.
-
Pull down the tab below the battery with your fingernail or an opening tool.
-
Lift the battery out.
-
-
-
Locate the five rubber covers on the back panel of the phone.
-
Use a metal probe to remove each rubber cover and expose the screws underneath.
-
-
-
Locate the six 2.5-millimeter Phillips #00 screws on the back panel.
-
Remove all six screws with a Phillips #00 screwdriver.
-
-
-
Locate the seam around the edge of the phone.
-
Insert a plastic opening tool into the seam and gently pry to release the tabs.
-
Work around the phone until all tabs are released.
-
Remove the back panel.
-
-
-
Locate the silver strip - closest to the bottom hinge of the phone - connected to the logic board.
-
Wedge the plastic opening tool in between the silver strip and the logic board.
-
Apply upward pressure with the plastic opening tool to separate the silver strip from the logic board.
-
-
-
Wedge the plastic opening tool in between the logic board and the phone.
-
Carefully pry these two pieces apart by going around the perimeter of the phone to separate the logic board from the phone.
-
-
-
Locate the back of the inside keyboard.
-
Take out the inside keyboard. By using your fingernails to pull one of the corners up, you can snap this piece out of its encasement.
-
Replace the keyboard by snapping the new keyboard into place, and begin to follow the steps in reverse to reassemble the device.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 16-55, Forte Fall 2012 crwdns2935289:0Cal Poly, Team 16-55, Forte Fall 2012crwdne2935289:0
CPSU-FORTE-F12S16G55
crwdns2931471:05crwdne2931471:0
crwdns2935297:014crwdne2935297:0
