crwdns2915892:0crwdne2915892:0
If you have broken or scratched your screen you may want to replace it with a new one.
crwdns2942213:0crwdne2942213:0
-
-
Turn the phone so the back side is face up.
-
-
-
Use your thumb to press on the small ridge at the bottom of the phone, then push upward to slide off the back casing.
-
-
-
Use your index finger to pull the top of the battery out from the top center divot. Then pull the battery towards yourself to remove it from the compartment.
-
-
-
Use a Phillips #00 screwdriver to remove the six 2.4mm screws, which secure the back panel.
-
-
-
Push a spudger or small tool under the inner edge of the back panel and gently pry upward to separate it from the main body.
-
-
-
Pop off the camera, lock, and volume buttons from the side of the phone using tweezers.
-
-
-
Use the Phillips #00 screwdriver to remove the two 3mm screws, which secure the motherboard.
-
-
-
-
Carefully lift and remove the motherboard from the main body.
-
-
-
Carefully unclip the metal tab to separate the connector cable from the motherboard.
-
-
-
Once the connector cable is detached from the motherboard, you have successfully removed the motherboard from the phone.
-
-
-
Turn the motherboard over and carefully remove the keypad from the motherboard.
-
The keyboard may be sitting loosely in the case (not attached to the motherboard). Carefully remove keyboard from case.
-
-
-
After removing the motherboard and keyboard, unscrew eight 1.6mm Phillips #00 screws in the middle of the phone.
-
-
-
Remove slider piece.
-
Pay close attention that you don’t lose the spring.
-
Carefully remove the spring.
-
-
-
Remove six 2.25mm Phillips #00 screws along the outside of the case.
-
-
-
Using the plastic opening tool, carefully open and remove the case. Slide the tool along the edge and pry upwards to open.
-
-
-
Remove the black electrical tape holding the LCD to the screen.
-
-
-
Un-clasp the small tab in the top right corner.
-
-
-
Unhook the LCD from tabs on the bottom using the plastic opening tool.
-
-
-
Once you have removed the LCD, the front case/screen will be left.
-
If necessary, you may remove the call/mute/hang up button.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 9-41, Regan Spring 2012 crwdns2935289:0Cal Poly, Team 9-41, Regan Spring 2012crwdne2935289:0
CPSU-REGAN-S12S9G41
crwdns2931471:05crwdne2931471:0
crwdns2935297:019crwdne2935297:0
