crwdns2915892:0crwdne2915892:0
The guide outlines the steps necessary to replace the keypad on the LG VX8700. The keypad is used to to help direct actions on the phone.
crwdns2942213:0crwdne2942213:0
-
-
Remove the back cover by sliding the tab away from the phone using one finger.
-
-
-
Lift one side of the battery using a plastic opening tool or your fingers.
-
Carefully remove the battery and set it aside.
-
-
-
Remove the nine 4 mm screws from the back cover with a Phillips #0 screwdriver.
-
-
-
-
Insert the tip of the iFixit opening tool into the small notch on the side of the case.
-
Slide the opening tool along the seam and around the edge of the phone to separate the case.
-
-
-
Separate the two halves of the phone.
-
-
-
Hold the phone casing with one hand and the keypad assembly with the other.
-
Separate the phone casing from the keypad/motherboard.
-
-
-
Pull the two boards apart to separate the keypad from the motherboard.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 8-16, Maness Winter 2012 crwdns2935289:0Cal Poly, Team 8-16, Maness Winter 2012crwdne2935289:0
CPSU-MANESS-W12S8G16
crwdns2931471:04crwdne2931471:0
crwdns2935297:014crwdne2935297:0
crwdns2917034:0crwdne2917034:0
When I separated the two halves a small brass piece came out and your instructions do not show nor mention what this is or where it goes. Not even a caution about it coming out upon separation of the halves. It appears to belong on one of the screw posts and because it is brass I believe it is supposed to complete a circuit.
