crwdns2915892:0crwdne2915892:0
Steps to remove LG VX8550 screen
crwdns2942213:0crwdne2942213:0
-
-
Slide the battery release up.
-
-
-
Remove the battery by lifting away from the case.
-
-
-
Remove the 2 screw covers next to the rear speaker with a Push Pin.
-
-
-
Remove the 4 cover screws with a Philips #00 screwdriver.
-
-
-
Use the iPod opening tool to pry off the back casing.
-
-
-
Continue sliding the iPod opening tool around the seam of the casing to separate the front and back casings.
-
-
-
Remove the 2 screws from the back of the phone with a Phillips #00 Screwdriver.
-
-
-
-
Carefully lift up on the motherboard to see the ribbon cables underneath.
-
Use the spudger to carefully disconnect the ribbon cable from the motherboard.
-
-
-
Remove the motherboard from the front casing by lifting straight up.
-
-
-
Lay the phone with the screen facedown.
-
The 6 slider screws are visible.
-
-
-
Peel back but don't remove the blue tape to access the 2 center screws.
-
Remove the 6 slider screws with the Phillips #00 screwdriver.
-
-
-
Lift the keypad housing away from the slider.
-
-
-
Remove the 2 screw covers next to the speaker with a push pin next to the camera.
-
-
-
Remove the 6 screws with a Phillips #00 Screwdriver.
-
-
-
Use the ipod opening tool to pry the screen casing and the slider mechanism apart from each other.
-
-
-
Slide ribbon cable through the slider mechanism.
-
-
-
With the spudger, lift up under the connector to unplug it from the circuit board.
-
-
-
Lift and remove the blue tape from screen connector.
-
-
-
Lift the top edge of the screen using a pin to pry under the corner.
-
-
-
Grasp the ribbon cable near the connector and carefully slide it out of the white connector.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 34-55, Forte Spring 2010 crwdns2935289:0Cal Poly, Team 34-55, Forte Spring 2010crwdne2935289:0
CPSU-FORTE-S10S34G55
crwdns2931471:05crwdne2931471:0
crwdns2935297:022crwdne2935297:0
crwdns2947410:01crwdne2947410:0
What’s the process if I just need to replace the flex cable not the whole screen?
