crwdns2915892:0crwdne2915892:0
This guide will demonstrate how to safely replace a humidity sensor on your LG UD501KOJ5 dehumidifier.
crwdns2942213:0crwdne2942213:0
-
-
Unplug the dehumidifier then put on work gloves to protect your hands.
-
Remove the water collection bucket and set it aside.
-
Remove the air filter from the bottom of the front grille.
-
-
-
Using your Phillips #0 screwdriver, remove the two screws which are attached at the bottom of the front grille.
-
Lift the front grille up and off the front of the frame, carefully set it in front of the dehumidifier.
-
-
-
-
Remove the screws that secure the back panel to the dehumidifier.
-
Carefully remove the back panel from the dehumidifier.
-
Remove the screws at the side.
-
-
-
Remove the screws located at both sides of the back panel.
-
Remove the screws on the top left and top right which are connected to the control box.
-
Carefully remove the outer case.
-
-
-
Disconnect the sensor wire harness from the electronic control board.
-
Disconnect the wire harness from the collection bucket float switch.
-
Pull the evaporator thermistor out of the copper sleeve on the side of the evaporator coil.
-
-
-
Remove the humidity sensor from the evaporator fins.
-
Pull the sensor assembly out of the dehumidifier.
-
Remove any dust build-up with a dry cloth.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
York University, Team S1-G3, O'Regan Summer 2021 crwdns2935289:0York University, Team S1-G3, O'Regan Summer 2021crwdne2935289:0
YORK-O'REGAN-SU21S1G3
crwdns2934841:01crwdne2934841:0
crwdns2935303:01crwdne2935303:0
crwdns2917034:0crwdne2917034:0
I think the model number may be wrong.
https://www.lg.com/us/support/product/lg...
