crwdns2915892:0crwdne2915892:0
Remove the battery before removing the back controls to avoid electric shock. Do not lose any screws or the middle button of the back controls.
crwdns2942213:0crwdne2942213:0
-
-
Flip the LG K7 over so that the back of the phone is facing up.
-
Locate the small notch on the bottom left side of the phone.
-
-
-
Insert a plastic opening tool into the notch and lift the back cover upward while holding the bottom portion of the phone down to remove it.
-
-
-
-
Located to nine 3.4 mm screws that keep that keep the phones rear housing in tacked.
-
Using a Phillips 00 screwdriver remove all nine 3.4 mm screws.
-
-
-
Turn the phone over so the screen is facing up
-
Insert your plastic opening tool between the midframe and front panel assembly on the side of the phone.
-
Slide the plastic opening tool down the seams carefully to separate the screen from the rest of the phone housing.
-
-
-
Locate the ribbon cable that holds the camera's ribbon cable in place.
-
Carefully remove the camera's ribbon cable from the motherboard using the plastic removal tool.
-
Holding the camera ribbon you just released pull upwards and the camera should release from the case.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2915084:0crwdne2915084:0
USF Tampa, Team S2-G5, Nance Fall 2017 crwdns2935289:0USF Tampa, Team S2-G5, Nance Fall 2017crwdne2935289:0
USFT-NANCE-F17S2G5
crwdns2931471:03crwdne2931471:0
crwdns2935297:08crwdne2935297:0
