crwdns2915892:0crwdne2915892:0
Use this guide to replace the headphone jack in your LG G3 Vigor.
crwdns2942213:0crwdne2942213:0
-
-
Locate the notch on the bottom right of the phone.
-
-
-
Gently pull the cover on the back of the phone off to locate the battery.
-
-
-
Remove the battery by lifting from the slot at the bottom of the battery.
-
-
-
Remove the twelve Phillips #00 screws securing the midframe to the rest of the phone.
-
-
-
-
Work a plastic opening tool around the perimeter of the phone to separate the midframe from the rest of the phone.
-
-
-
Use the spudger to gently unplug the ribbon cable connected to the motherboard. Then remove the rear facing camera.
-
-
-
Use the spudger to gently unplug the ribbon cable connected to the motherboard.
-
Remove the front camera.
-
-
-
Use the flat edge of a spudger to disconnect the motherboard ribbon connector.
-
-
-
Use the pointed end of a spudger to push back the two motherboard retaining flaps.
-
The motherboard should now be able to be lifted out of the device.
-
-
-
Remove the headphone jack by inserting the spudger into the jack and pulling it up and out.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0
crwdns2917034:0crwdne2917034:0
Works also with D855. There are only a view differences, e.g. screws and a minimal different motherboarddesign.
