crwdns2915892:0crwdne2915892:0
This guide will show you how to replace the motherboard in your LG G Watch.
crwdns2942213:0crwdne2942213:0
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
First, slide the wristband down on the spring bar to expose the shoulder of the spring bar.
-
Grasp the exposed shoulder with the tweezers to perform the next step.
-
-
-
Use the tweezer to depress the spring bar so that it collapses by a few millimeters and pops out of the hole that was holding it in place.
-
Now carefully pull the other end of the spring bar to detach the wristband from the watch face.
-
-
-
Use the T5 Torx screwdriver to unscrew the four silver 2mm x 3mm T5 screws that hold the back cover in place.
-
-
-
-
Slide the opening pick between the rear case and the rest of the device to separate the two halves.
-
Gently pull the two halves apart.
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Use a pair of tweezers to remove the gasket that lies embedded in a groove that runs around the perimeter of the front half.
-
-
-
Use the spudger to gently lift up and disconnect the display connector.
-
Now use the spudger to disconnect the digitizer connector.
-
-
-
Use a Phillips #000 screwdriver to remove the two black PHO 2.5mm x 3mm screws.
-
Use the spudger to gently remove the motherboard.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:04crwdne2935229:0
crwdns2915084:0crwdne2915084:0
USF Tampa, Team 2-5, Blackwell Fall 2014 crwdns2935289:0USF Tampa, Team 2-5, Blackwell Fall 2014crwdne2935289:0
USFT-BLACKWELL-F14S2G5
crwdns2931471:05crwdne2931471:0
crwdns2935297:09crwdne2935297:0
crwdns2947410:01crwdne2947410:0
is it possible to replace the battery which is in the board?
