crwdns2915892:0crwdne2915892:0
Use this guide to install a new logic board in your LG Dare.
crwdns2942213:0crwdne2942213:0
-
-
Remove the back cover by firmly pressing against the raised lip on the back panel. Slide the cover towards the top of the phone.
-
-
-
Remove the battery by placing your fingernail or a opening tool in the recessed edge and lift the battery out.
-
-
-
Use the #00 screwdriver to remove the six 4mm phillips screws located around the edges of the phone.
-
-
-
-
Lift the back plastic cover off by moving the opening tool around the edges of the phone.
-
Wedging the opening tool in several places on the bottom of the phone will help release small tabs that hold the back to the front frame.
-
-
-
Pull off the back plastic panel.
-
Remove the buttons from the edge of the frame. The buttons are [lock], [volume control], [speaker], and [camera].
-
-
-
Disconnect the three ribbon connectors from the motherboard.
-
-
-
Remove the LED.
-
Remove the camera connector.
-
Remove the camera sensor from the logic board. Squeeze the sides of the camera sensor firmly and pull straight up.
-
-
-
Use the opening tool to lift up the green logic board in all areas and remove it.
-
To re-assemble your device, follow these instructions in reverse order.
To re-assemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0