crwdns2942213:0crwdne2942213:0
-
-
Insert the plastic opener into the slot at the top of the device.
-
Apply gentle pressure with the plastic tool to pop the back case off.
-
-
-
Use the plastic opener to lift, and remove, the device battery.
-
-
-
Use a screwdriver and corresponding bit to remove the six 2mm screws that are located along the edge of the rear case. Set the screws aside.
-
-
-
Use the plastic opener to pry the rear case loose.
-
-
-
-
Use a screwdriver and corresponding bit to remove the two 3mm screws that attach the motherboard to the front case. Set the screws aside
-
-
-
Rotate the phone 180 degrees and use the plastic opener to lift the metal piece that covers the ribbon cable.
-
-
-
Use the plastic opener to disconnect the ribbon cable.
-
-
-
Use tweezers to disconnect the two cables that attach the motherboard to the case.
-
-
-
Remove the motherboard from the front case.
-
-
-
Flip the front case over. If the keyboard doesn't fall out, push it through the front case.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2915084:0crwdne2915084:0
Clemson, Team 13-1, Benson Fall 2013 crwdns2935289:0Clemson, Team 13-1, Benson Fall 2013crwdne2935289:0
CLEM-BENSON-F13S13G1
crwdns2931471:03crwdne2931471:0
crwdns2935297:016crwdne2935297:0
