crwdns2942213:0crwdne2942213:0
-
-
Find a sliding button on the lower back side of the device and with your finger, slide it to the left firmly.
-
-
-
You will need to use a Phillips #00 screwdriver.
-
Remove the four screws located at the corners beneath the battery.
-
Detach the back case from the phone.
-
-
-
Take the case off by using a plastic opening tool.
-
Continue using the plastic opening tool around the sides of the device.
-
Unhook the eight tabs securing the back cover to the rest of the phone as seen in the second photo.
-
The back speaker will be connected to the motherboard.
-
This must be disconnected in order to remove the case
-
-
-
Unscrew the 4 Phillips 00 screws that connect the two halves of the phone together.
-
-
-
Between the two halves is a ribbon. Use a plastic opening tool to flip up the lock and disconnect it.
-
-
-
-
Pry off the plastic tabs that cover two screws, as shown in the first picture.
-
Then, remove the 6 Phillips 00 screws from the back of the case, as shown in the second picture.
-
-
-
Pry off the back cover from the front of the case using a plastic opening tool.
-
-
-
Pry the front speaker and wireless receiver out of the front case using a spudger.
-
-
-
Starting with the side that has the speaker and receiver, carefully lift the LCD Board out of the case.
-
-
-
Unhook the ribbon cable using that flat side of a spudger.
-
-
-
Next, carefully remove the tape from the LCD board.
-
-
-
Finally, flip up the black switch to unhook the LCD screen from the LCD board using a spudger.
-
The LCD Board in now accessible.
-
-
-
The side buttons can now be accessed freely.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 19-46, Regan Winter 2013 crwdns2935289:0Cal Poly, Team 19-46, Regan Winter 2013crwdne2935289:0
CPSU-REGAN-W13S19G46
crwdns2931471:04crwdne2931471:0
crwdns2935297:022crwdne2935297:0
