crwdns2942213:0crwdne2942213:0
-
-
Turn off the cell phone and place face down on a flat surface.
-
-
-
While sliding the gray tab up, lift battery up and away from the cell phone.
-
-
-
Use a Spudger to remove the two front plastic covers to reveal screws.
-
-
-
Remove two screws using a Torx T6 screwdriver.
-
-
-
Pry off the screen front cover with a small flathead screwdriver.
-
-
-
-
Insert a small flathead screwdriver into the hinge and separate hinge connection.
-
-
-
Pry off the speaker which is glued on to the front cover using a small flathead screwdriver.
-
-
-
Remove remaining portion of the front case from the flexible circuit board.
-
-
-
Unscrew the four screws on the back case using a T6 Torx Screwdriver.
-
-
-
Pull the back cover straight off the phone using your thumb and forefinger.
-
-
-
Pry off circuit board with a flathead screwdriver.
-
-
-
The phone should now look like the picture to the left.
-
-
-
Locate and detach the ribbon cable from circuit board.
-
-
-
Remove the LCD Screen from the phone case and replace with a new LCD screen.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 3-25, Regan Fall 2010 crwdns2935289:0Cal Poly, Team 3-25, Regan Fall 2010crwdne2935289:0
CPSU-REGAN-F10S3G25
crwdns2931471:04crwdne2931471:0
crwdns2935297:014crwdne2935297:0
