crwdns2915892:0crwdne2915892:0
Follow this guide to replace the motherboard in your Kurio Xtreme. Before you begin, make sure that you have a soldering iron and know how to use it.
crwdns2942213:0crwdne2942213:0
-
-
Remove the rubber case by beginning to peel from one of the top corners and continue peeling until the cover is completely removed.
-
-
-
Unscrew the four 4 mm black screws using a Phillips #000 screw driver.
-
-
-
Insert the plastic opening tool in between the edges of the blue front casing and black back casing.
-
Slide the plastic opening tool around the perimeter of the device. This may require that you repeatedly run the opening tool up and down the edges of the device.
-
Carefully lift the back panel off of the rest of the device.
-
-
-
-
Unscrew the three 4 mm screws with a Phillips #000 screwdriver.
-
-
-
Remove the orange data display ribbon wire above the battery by prying open the ZIF connector with the plastic opening tool.
-
-
-
Remove the orange data display ribbon wire to the left of the battery by prying open the ZIF connector with the plastic opening tool.
-
-
-
Remove the 7 wires connected to the motherboard by soldering the ends that connect them to the motherboard.
-
2 pairs of red and black speaker wires (4 wires total)
-
1 pair of red and black battery wires (2 wires total)
-
1 gray ground wire
-
-
-
Remove the motherboard by lifting it out of the casing.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2915084:0crwdne2915084:0
Baylor, Team 6-10, Williams Fall 2015 crwdns2935289:0Baylor, Team 6-10, Williams Fall 2015crwdne2935289:0
BU-WILLIAMS-F15S6G10
crwdns2931471:03crwdne2931471:0
crwdns2935297:014crwdne2935297:0
