crwdns2915892:0crwdne2915892:0
Is your tablet not accepting charge, won't show things on screen, or you don't have audio? If you have tried changing the battery, screen, and audio jack and still have these problems, that means you need to change your mother board. This guide will require soldering so refer to this guide.
crwdns2942213:0crwdne2942213:0
-
-
Use the Phillips #0 Screwdriver to remove four 5mm screws from sides of the device.
-
-
-
Use the Ifixit opening tool to pry open the device to remove the back of the Kurio Motion.
-
-
-
Remove the tape covering the tape from the edges of the battery.
-
-
-
-
Remove the orange connectors that are connected to the motherboard by lifting up the white tab, and then gently pulling the connector out.
-
-
-
Take out the 5mm screws located at the top right and left of the motherboard.
-
-
-
Remove the tape covering the camera gently.
-
-
-
Use your spudger to carefully take out the camera.
-
-
-
Use your soldering tool to solder the wires that are connected to the battery and the gray wire next them.
-
-
-
Use your soldering tool to solder the wires that are connected to the speakers.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
University of New Orleans, Team 3-7, McDonald Fall 2023 crwdns2935289:0University of New Orleans, Team 3-7, McDonald Fall 2023crwdne2935289:0
UNO-MCDONALD-F23S3G7
crwdns2931471:03crwdne2931471:0
crwdns2935297:04crwdne2935297:0
