crwdns2915892:0crwdne2915892:0
The lens cover protects the lens of the camera from being scratched or damaged while not in use. If the cover breaks or cracks and a replacement needs to be done, you can follow the steps in the following guide.
-
-
Remove lens cover from the camera by squeezing the protruding button on each side of the cover and pulling.
-
-
-
Pull the lens cover string toward the ground so that the loop underneath the metal slab is on top of the cover string.
-
Push up so that the string starts to come out of the top of the loop.
-
Grab the string from above the loop and pull.
-
-
-
-
Feed the string on top into the metal slab while pulling the loop toward you until the plastic piece stops you from pulling any further.
-
-
-
Separate the two pieces of the loop and pull the lens cover up in between them.
-
-
-
Pull the lens cover and the sting will come out of the metal slab.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0