crwdns2915892:0crwdne2915892:0
How to replace an unusable or damaged button on your Kodak EasyShare LS743. Be sure to remove the battery from your camera prior to starting this repair.
crwdns2942213:0crwdne2942213:0
-
-
Using your fingernail, open the battery cover.
-
-
-
Slide the orange latch sideways to eject the battery.
-
Remove the battery from the battery slot.
-
-
-
Using a Phillips #00 screwdriver, remove two 5.39 mm screws next to the battery slot.
-
Remove the metal piece holding down the lanyard, then remove the lanyard.
-
-
-
Using a Phillips #00 screwdriver, remove seven screws located on the outside case of the camera.
-
One 6.25 mm screw is located on the top right corner, right to the "OK" button.
-
Four 4.45 mm screws are on the bottom of the camera.
-
Two 2.95 mm screws are on the left side of the camera, above the USB port.
-
-
-
Carefully remove the rear camera casing.
-
Carefully remove the front camera casing.
-
-
-
-
Remove the top panel screw (1x 4.37mm).
-
-
-
Remove the back panel screws (1x 3.33mm, and 1x 3.40mm).
-
-
-
Separate the inner casing from the tripod mount.
-
-
-
Gently pull the orange tab out of the circuit board.
-
-
-
Remove the (1x 3.33mm) screw from the menu button panel .
-
-
-
Pull the second orange tab from the circuit board and remove the buttons.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 2-8, Johann Summer 2010 crwdns2935289:0Cal Poly, Team 2-8, Johann Summer 2010crwdne2935289:0
CPSU-JOHANN-R10S2G8
crwdns2931471:05crwdne2931471:0
crwdns2935297:016crwdne2935297:0
