Klipper Power On Button

crwdns2931653:01crwdne2931653:0 Wiring




• You will be removing the yellow and green wires from terminal 1 and 2 from step 2
• Re-crimp the wires and using a 3 pin connector. Connect it to E1_STOP on the Duet
• Polarity of the green and yellow wire doesn't matter.
• Add the commands for "output_pin psupower" "gcode_macro M80" "gcode_macro M81" and "gcode_button power_on" to your printer.cfg
• I've uploaded my config to my github
crwdns2913378:0crwdne2913378:0
crwdns2935263:02crwdne2935263:0
crwdns2934285:0crwdne2934285:0
crwdns2917038:0crwdne2917038:0
1024
crwdns2891542:0crwdne2891542:0 crwdns2934287:0crwdne2934287:0

crwdns2862417:0crwdne2862417:0

David Husolo

crwdns2935283:006/16/21crwdne2935283:0

8,752 crwdns2915208:0crwdne2915208:0

crwdns2935297:033crwdne2935297:0

crwdns2918514:0crwdne2918514:0: 16

• 
• 
• 

crwdns2935301:013crwdne2935301:0

crwdns2942557:0crwdne2942557:0

crwdns2942955:0crwdne2942955:0

crwdns2852917:0crwdne2852917:0