crwdns2915892:0crwdne2915892:0
If your device is not turning on it could be because of worn down carbon brushes. Here is a guide to replace these brushes.
crwdns2942213:0crwdne2942213:0
-
-
Using a flat head screwdriver, unscrew the brush cap on each side of the mixer by turning them counter clockwise.
-
Remove brush cap by pulling it toward you.
-
-
-
-
Remove brush by pulling it toward you.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:06crwdne2935229:0
crwdns2915084:0crwdne2915084:0
Cal Poly, Team S2-G5, Livingston Winter 2018 crwdns2935289:0Cal Poly, Team S2-G5, Livingston Winter 2018crwdne2935289:0
CPSU-LIVINGSTON-W18S2G5
crwdns2931471:04crwdne2931471:0
crwdns2935297:010crwdne2935297:0
crwdns2917034:0crwdne2917034:0
I’ve been procrastinating on trying to fix my KA mixer on my own…today I did it. The directions were pretty clear and the only thing wrong was that when I had previously cleaned my mixer, I put the carbon brushes in the wrong way. Once I shined a flashlight into the hole I could see where the notched corner went.
