crwdns2915892:0crwdne2915892:0
If you are worried about oil or grease leaking inside or out of your mixer, you might have to replace your gasket. This guide will show you how to do this.
crwdns2942213:0crwdne2942213:0
-
-
Using a spudger, gently pry off the aluminum drip ring.
-
-
-
Using a 4 mm pin punch and hammer, hammer the pin until it is dislodged from the planetary gear cover.
-
-
-
Using a spudger, pry the planetary gear cover from the mixer shaft.
-
-
-
Using a flathead screwdriver, remove the five 28 mm front motor housing screws.
-
Using the same flathead screwdriver, remove the two 28 mm locking screws.
-
-
-
-
Turn your device around. Using the same flathead screwdriver, remove the two 28 mm rear locking screws.
-
-
-
Using a Phillips #2 screwdriver, remove the 10 mm screw from top of back cover.
-
-
-
Carefully pull the power cord from the notch in back of the mixer.
-
-
-
Lift the motor housing cover from the mixer base.
-
-
-
Use a butter knife or putty knife to remove grease from around the gasket.
-
Place grease in motor housing cover.
-
-
-
Lift the gasket up with your hands or a spuger and remove it.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:07crwdne2935229:0
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 14-28, Maness Fall 2014 crwdns2935289:0Cal Poly, Team 14-28, Maness Fall 2014crwdne2935289:0
CPSU-MANESS-F14S14G28
crwdns2931471:04crwdne2931471:0
crwdns2935297:022crwdne2935297:0
crwdns2944067:02crwdne2944067:0
I got all the way to the last step of replacing the pin when i notice the mixer seemed to lock there in place and not move. What did i do wrong?
Dawn dawn6463@yahoo.com
Hi there - There is a gasket around the engine part that you can see in step 7. Mine tore when I removed it. Is that a bad thing? I put the machine back together and it seems to work.
