crwdns2915892:0crwdne2915892:0
You will need a small Phillips head screwdriver and a soldering device to complete this project.
crwdns2942213:0crwdne2942213:0
-
-
Place the Walkie-Talkie on a flat surface-preferably a table or a desk.
-
Flip the device over to where you see four screws in each corner.
-
Make sure you take out the batteries before proceeding.
-
-
-
Using your Phillips head screwdriver, unscrew all four 4mm screws from each corner.
-
-
-
-
Once you have unscrewed all four corners, open the device so it will be in two parts.
-
Taking the Phillips head screwdriver again, unscrew the three screws on the circuit board (green plate).
-
-
-
Take the circuit board out of the plastic casing.
-
Use the soldering device to iron the silver box (press-to-speak button), and then remove it from the circuit board.
-
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0