crwdns2942213:0crwdne2942213:0
-
-
Remove both 8.0 mm Phillips #1 screws, one for each wheel.
-
-
-
Remove the wheels by pulling them away from the RC car.
-
-
-
-
Remove the eight 8.0mm Phillips #00 screws, two screws for each wheel.
-
-
-
Pry open the two gear covers on both sides.
-
-
-
Pull the driving gears off the axles by sliding them off the axles and exposing both axles.
-
-
-
Slide both axles from the internal axles guides within the car.
-
Reverse the steps to replace the axles.
-
crwdns2935219:0crwdne2935219:0
To reassemble your device, follow these instructions in reverse order.
crwdns2915888:0crwdne2915888:0
To reassemble your device, follow these instructions in reverse order.