crwdns2915892:0crwdne2915892:0
This guide shows how to replace the coupling on a Kenwood CH250 blender.
crwdns2942213:0crwdne2942213:0
-
-
Remove the small cap covering the screw holding the coupling onto the shaft, using a small flat-head screw driver.
-
-
-
Unscrew the screw holding the coupling onto the shaft, using the PH1 screw driver.
-
-
-
-
Put the plastic washer onto the shaft, then place the metal washer on top of the plastic washer.
-
Note: the old coupling did not have any washers.
-
-
-
Push the new coupling onto the shaft.
-
-
-
Secure the coupling with the screw, using the PH1 screw driver.
-
-
-
Finally, put the cap on top of the screw and press in place with the flat-head screw driver.
-
crwdns2935219:0crwdne2935219:0
crwdns2935217:0crwdne2935217:0
