crwdns2915892:0crwdne2915892:0
Use this guide to replace a faulty lid switch on your Kenmore 110 series washing machine.
crwdns2942213:0crwdne2942213:0
-
-
Using a 5/16" socket wrench or an adjustable wrench, remove the three screws from the top rear of the washer.
-
Lifting from the rear, remove the top panel.
-
Set the top panel on its rear face, with its underside facing you.
-
-
-
-
Using a 5/16" socket wrench or hand wrench, remove the two screws from the component cover.
-
Gripping from the bottom, pull the component cover out of the washer.
-
-
-
Carefully unplug the two wires connected to the lid switch.
-
Remove the two Phillips screws securing the bracket.
-
Remove the green ground wire.
-
With a screwdriver, remove the single screw connecting the lid switch to the bracket.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:09crwdne2935229:0
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 15-43, Forte Fall 2012 crwdns2935289:0Cal Poly, Team 15-43, Forte Fall 2012crwdne2935289:0
CPSU-FORTE-F12S15G43
crwdns2931471:05crwdne2931471:0
crwdns2935297:011crwdne2935297:0
crwdns2944067:014crwdne2944067:0
My Kenmore Model 110.24622300 does NOT look anything like this!
my model # 11088732796 is not the same as yours
No it ia neither of those. Thank for the reply though. My washer is a 90 series.
Lol I found the solution on YouTube. All it takes is a zip tie because the lid switch for he 90s series Kenmore washer is two half pieces glued together
my Kenmore washer model# is 110.24812200; series CP2654205. Cannot remove top to repair lid switch following your video! removed the three screwsf from the back but cannot get control panal to come off! Please reply soon.
