crwdns2915892:0crwdne2915892:0
This guide shows how to remove and replace the vacuum motor for a Karcher Vacuum Universal 14286230 2014.
When you perform this repair, it is a good opportunity to replace the two rubber motor seals:
- Part 6.903-300.0 (69033000)
- Part 6.903-246.0 (69032460)
crwdns2942213:0crwdne2942213:0
-
-
Release the two latches locking the top assembly in place.
-
-
-
Lift and remove the top assembly from the tank.
-
-
-
Remove the four T15 screws securing the top assembly.
-
-
-
Carefully lift the motor/filter away from the housing until you can access the motor wires.
-
-
-
-
Disconnect the two motor wires from the motor by pulling them straight out of their sockets.
-
-
-
You can now fully remove the motor/filter assembly from the housing.
-
Reassembly tip: Use the alignment tab to help you align the motor/filter with the housing assembly.
-
-
-
Remove the four T15 screws securing the motor flange.
-
-
-
Lift the motor flange and remove it from the motor assembly.
-
Re-assembly tip: Use the marked notch to help you align the motor flange to the assembly.
-
-
-
Lift the motor straight out of the assembly and remove it.
-
-
-
Peel and remove the two black rubber seals from the motor.
-
Transfer the rubber seals to the replacement motor.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:04crwdne2935229:0
crwdns2947410:01crwdne2947410:0
Part number for the filter nut: Karcher NT 27/1 48/1 Vacuum Hoover Holder Filtering Basket 9.411-954.0