crwdns2915892:0crwdne2915892:0
Follow this guide to remove the primary plastic housing cover on the Karcher Rotary Floor Cleaner 17833080 2017 for further disassembly.
crwdns2942213:0crwdne2942213:0
-
-
Lift the tank by the handle and remove it from the device.
-
-
-
Press the yellow button near each wheel base to release the wheels.
-
Remove both wheels from their sockets.
-
-
-
Press the yellow foot switch at the base of the device to lower the suction bars.
-
-
-
Raise the handle to the upright position.
-
-
-
Engage the retaining bracket to lock the handle in place.
-
-
-
Grasp the handle and carefully tilt the device onto its side.
-
-
-
Tilt the top of the roller brush out of the brush well.
-
Remove both roller brushes.
-
-
-
Press the yellow button on the suction bar retaining bracket to release the suction bar.
-
-
-
-
Remove both suction bars.
-
Reassembly tip: When you re-insert the suction bars, be sure to orient the locking tab towards the center of the device. This allows the bars to click in place.
-
-
-
Use a T20 driver to remove the three screws securing the pump cover.
-
-
-
Squeeze the right plug by the edges and pull it out of its socket.
-
-
-
Remove the following screws securing the left retaining bracket:
-
Four T40 screws
-
Two T20 screws
-
-
-
Raise the handle to the upright position.
-
Engage the retaining bracket to lock the handle in place.
-
-
-
Use a T20 driver to remove the two screws securing the right splash guard.
-
-
-
Use a T20 driver to remove the following screws securing the right retaining bracket:
-
Two 85 mm-long screws
-
Four 45 mm-long screws
-
-
-
Lift the handle assembly away from the device and remove it.
-
-
-
Disconnect the two remaining plugs by squeezing the edges and pulling them out of their sockets.
-
Vacuum motor
-
Pump
-
Handle
-
-
-
Use a T20 driver to remove the six screws securing the plastic brush housing.
-
-
-
Lift the brush housing away from the device and remove it.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
