crwdns2942213:0crwdne2942213:0
-
-
Remove each ear cushion by hooking your fingers along the inside of the ear cushion and pulling up and away from the ear cup.
-
If the cushion does not fully release, move your hand to the opposite side and pull up inn the same manner.
-
-
-
Using the small plastic spudger to assist, begin lifting up and removing the foam inserts with attached backing tape.
-
-
-
Repeat the previous steps for the other side, removing the foam inserts with care.
-
-
-
-
Unscrew and remove the four T6 screws holding the speaker in place.
-
-
-
Repeat the previous step for the other side, removing the four T6 screws.
-
-
-
Tilt the headphones over so that the speaker tilts out of the plastic holder.
-
Repeat for both sides.
-
-
-
Remove the four screws attaching the circuit boards to the headphone enclosure.
-
-
-
Remove the circuit boards from the headphone enclosure.
-
Carefully lift the bar located on the lower circuit board that contains the 24-pin ribbon cable. Remove the cable.
-
If the microphone on your Jabra Elite 85h is not working, replacement could be an appropriate solution.
If the microphone on your Jabra Elite 85h is not working, replacement could be an appropriate solution.