crwdns2915892:0crwdne2915892:0
Without the speaker, the speakerphone would be useless! This guide will tell you step-by-step how to remove and replace a faulty speaker.
crwdns2942213:0crwdne2942213:0
-
-
Use the iOpener tool to unglue the adhesive of the device. The link to the iOpener instructions are listed below.
-
-
-
Place the flat head of the bigger plastic opening tool in between the front plate and back plate.
-
Pull the tool toward the back of the device to pry it open.
-
Repeat this process over all edges of the device.
-
-
-
Open up the device by pulling the front plate straight up from the back plate.
-
-
-
-
Carefully unplug the red and black wires that run from the speaker to the motherboard by detaching the white connecting piece.
-
-
-
Using the PH000, unscrew the two 5.5mm screws attaching the speaker to the front plate.
-
The screwdriver sizes are located on the sides of their heads.
-
-
-
Gently pull the black and red wires away from the back plate to remove the speaker.
-
-
-
Carefully pull the wires away from the speaker, detaching them from the adhesive, while keeping the ends intact.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
Baylor, Team 8-13, Williams Fall 2014 crwdns2935289:0Baylor, Team 8-13, Williams Fall 2014crwdne2935289:0
BU-WILLIAMS-F14S8G13
crwdns2931471:03crwdne2931471:0
crwdns2935297:05crwdne2935297:0
crwdns2947412:05crwdne2947412:0
Is this a fairly standard speaker? With radio shack dead, can you suggest a source? Any specs? Yhanks
Did you ever find a speaker for your jabra cruiser?
halo
where i can get the new speaker for jabra cruiser 2?
simple speaker in electronic parts shop 8ohm diameter 35mm price 1.2 €
A 36 mm speaker will also fit nicely. A 1 watt 8 ohms speaker is the best choice - the amplifier is not able to output enough power to drive a 2+ watt speaker.
