crwdns2915892:0crwdne2915892:0
The motherboard is the most important part of the Jabra CRUISER2. It controls the device. This guide will tell you step-by-step how to remove the motherboard so you can replace it with a functioning one.
crwdns2942213:0crwdne2942213:0
-
-
Use the iOpener tool to unglue the adhesive of the device. The link to the iOpener instructions are listed below.
-
-
-
Place the flat head of the bigger plastic opening tool in between the front plate and back plate.
-
Pull the tool toward the back of the device to pry it open.
-
Repeat this process over all edges of the device.
-
-
-
-
Open up the device by pulling the front plate straight up from the back plate.
-
-
-
Carefully detach the wire running from the speaker to the motherboard by unplugging it from the white socket.
-
-
-
Using the PH000, unscrew the three 4.55 mm screws in the motherboard.
-
The names of the screwdriver heads are listed on the sides of each head.
-
-
-
Remove the motherboard from the device by lifting it up from the back plate.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.