crwdns2915892:0crwdne2915892:0
Taking out the speaker for a replacement
crwdns2942213:0crwdne2942213:0
-
-
Insert the flat edge of the metal spudger underneath the corner of the outer case.
-
Use the spudger to pry open the plastic clips that secure the outer case.
-
-
-
Once all the clips are released, you will be able to pull up that edge of the case.
-
-
-
Once one side is released, complete the previous two steps with the other side.
-
-
-
-
Once all the clips are removed, you can gently remove the outer case.
-
The case is now fully removed. Now a new case will be attached by putting the case into position and pushing on the clips to reattach them.
-
-
-
Begin by unscrewing the four 9.6 mm-long screws with the Philips #00 screwdriver.
-
-
-
Once screws are fully out make sure to carefully pull out so the wires connected don't get damaged.
-
-
-
Once you carefully lift up the speaker, gently disconnect the wire that connects the speaker to the motherboard.
-
-
-
Once connection has been disconnected you can lift the speaker completely out.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0