crwdns2915892:0crwdne2915892:0
How to disassemble the JBL Charge 2 for replacing speakers.
crwdns2942213:0crwdne2942213:0
-
-
Remove the screen cover from the speaker using a metal spudger.
-
-
-
Using a Phillips #1 screwdriver (PH1), remove the (4) four 8mm screws.
-
Remove the end cap of the device. Repeat the same process to remove the other end cap.
-
-
-
To remove the end diaphragms, use a Phillips #1 screwdriver (PH1) and remove the (4) four 6mm screws.
-
Twist off the end cap and remove them from the device.
-
-
-
-
Use a Phillips #1 screwdriver (PH1) to remove the (2) two screws from the battery cover.
-
Pry away the plastic battery cover with a plastic spudger.
-
-
-
Disconnect the battery connector with a plastic opening tool and wiggle the connector free.
-
-
-
Scrape the battery wire sealant off with a plastic opening tool, and ensure it is free of the body of the speaker and wires.
-
Slide the battery free.
-
-
-
Remove the opposite screen cover using a metal spudger
-
-
-
Use the Phillips #1 screwdriver (PH1) to remove the (8) eight screws.
-
Pull out the speakers from the device.
-
-
-
Disconnect the wiring from the speaker by using the fine tip pry tool.
-
Remove the speakers from the device.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0