crwdns2915892:0crwdne2915892:0
Use this guide to replace the infrared sensor in your Insignia NS-24ER310NA17 television.
crwdns2942213:0crwdne2942213:0
-
-
Rest the TV on its top edge so you have access to the base.
-
Use a Phillips #2 screwdriver to remove the four screws on the bottom of the base.
-
Remove the base from the frame.
-
-
-
Lay the TV face down.
-
Use the Phillips #00 screwdriver to remove all of the screws from the the back of the TV.
-
-
-
Stand the TV on its top edge.
-
Gently pry apart the front and back of the TV.
-
-
-
Remove all the pieces of tape to detach the wires from both sides.
-
You want to gently peel the tape off, without pulling on the wires.
-
-
-
Spread apart your TV the rest of the way, but do not disconnect any of the wires.
-
-
-
Remove all strips of tape attached to the silver steel rectangular piece.
-
-
-
-
Pull the red wire out from under the black plastic clip.
-
-
-
Unscrew the four screws surrounding the steel rectangle with a Phillips 00 Screwdriver.
-
-
-
Carefully lift the rectangular piece.
-
-
-
The rectangular piece will still be attached to the motherboard beneath it with a strip of tape. Remove this strip of tape.
-
-
-
Use a Phillips #00 screwdriver to remove the two screws on both sides of the motherboard.
-
-
-
Carefully lift the motherboard away from the television.
-
-
-
There are 5 wires attached to the motherboard. Remove the two thicker white wires to the right of the red wire.
-
-
-
Remove the remaining three wires from the mainboard.
-
-
-
Carefully remove the mainboard from the television.
-
You have now successfully removed the mainboard.
-
-
-
Unplug the ribbon cable from the port on the main board that corresponds with the IR sensor.
-
-
-
Remove the single screw holding the IR sensor and remove the sensor with the ribbon cable.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0