crwdns2915892:0crwdne2915892:0
Float valves may wear out over time, preventing them from rising or falling correctly. This guide will demonstrate how to replace the float valve.
-
-
Remove the lid and place it upside-down on a flat surface.
-
-
-
-
Pinch the rubber gasket on the float valve and pull up.
-
-
-
Pull the rubber gasket off of the metal rod.
-
The valve will fall out of its hole onto the table. It can now be cleaned or replaced.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:03crwdne2935229:0
crwdns2915084:0crwdne2915084:0
Cal Poly, Team S12-G3, Banghart Winter 2018 crwdns2935289:0Cal Poly, Team S12-G3, Banghart Winter 2018crwdne2935289:0
CPSU-BANGHART-W18S12G3
crwdns2931471:04crwdne2931471:0
crwdns2935297:05crwdne2935297:0
crwdns2947412:03crwdne2947412:0
I received the replacement valve and pot. Now my insignia instapot won't hold pressure. It keeps seeping steam/spritz out of the float valve. I am ready to toss it in the trash. It worked bafore I replaced that stem. I should've kept it.
OK after much digging, I found the old valve and now it is pressurizing.
where can I buy the float valves
