crwdns2942213:0crwdne2942213:0
-
-
Using the plastic opening tool, remove screen protector from front of monitor.
-
-
-
Remove the six 4mm screws using a Phillips #00 screwdriver.
-
Remove the screen, exposing the circuit board.
-
Turn device over to expose rear circuit board.
-
-
-
Disconnect speaker from monitor for ease of access by unplugging wire.
-
-
-
-
Unscrew the four 3 mm screws holding the motherboard to the unit using a Phillips #00 screwdriver.
-
-
-
Flip the device over, and de-solder the defective charging port using the soldering iron.
-
-
-
Remove the old charging port and solder the new one in place.
-
-
-
Flip the unit over to ensure a correct fitment.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 13-4, Banghart Winter 2017 crwdns2935289:0Cal Poly, Team 13-4, Banghart Winter 2017crwdne2935289:0
CPSU-BANGHART-W17S13G4
crwdns2931471:04crwdne2931471:0
crwdns2935297:04crwdne2935297:0
crwdns2944067:02crwdne2944067:0
I appreciate you posting this. What kind of new charging port did you use (USB type, size, etc) and does IFIXIT sell them?
The part you are looking for is a female Micro USB B-Type solder socket. I no longer have the unit available to confirm, but I'll bet you could contact Infant Optics and confirm with them. Sorry I can't be of more help!
