crwdns2915892:0crwdne2915892:0
This guide will assist with replacing a non-functioning projector lamp, which is responsible for providing the light necessary for projection.
crwdns2942213:0crwdne2942213:0
-
-
Place the projector on its back with the control buttons facing down.
-
Remove the black 7mm screw on the external case with a Phillips 2 screwdriver.
-
-
-
Use the plastic flat-head to remove the lamp lid.
-
-
-
-
Remove the 7mm screw near the bottom center with a Philips 2 screwdriver head.
-
Loosen but do not remove the 7mm screw near the upper right corner with the Phillips 2 screwdriver head.
-
-
-
Grab the silver handle.
-
Unhook the handle so it can move freely.
-
Pull the handle straight up until the lamp is completely removed from projector.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 13-17, Regan Winter 2014 crwdns2935289:0Cal Poly, Team 13-17, Regan Winter 2014crwdne2935289:0
CPSU-REGAN-W14S13G17
crwdns2931471:06crwdne2931471:0
crwdns2935297:05crwdne2935297:0
