crwdns2915892:0crwdne2915892:0
Use this guide if your Huawei Union will not charge when plugged into a charger or begins losing charge faster than previously observed.
crwdns2942213:0crwdne2942213:0
-
-
Wedge your thumb nail, or the flat end of a spudger, into the bottom left corner and pry off.
-
-
-
Use the flat end of a spudger, or fingernail, to lift up the battery and pull out.
-
-
-
Remove the thirteen 3mm Phillips #00 screws from the back panel.
-
-
-
-
Use the flat end of a spudger to pry off the back panel.
-
-
-
Remove a single 3mm Phillips #00 screw from the motherboard.
-
-
-
Using the flat end of a spudger to disconnect the motherboard ribbon cable.
-
-
-
Firmly hold the second ribbon cable's plastic film cover and pull up to disconnect.
-
-
-
Wedge the flat end of a spudger underneath the motherboard and pry upwards to separate it from the frame.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2915084:0crwdne2915084:0
USF Tampa, Team S1-G1, Nance Spring 2018 crwdns2935289:0USF Tampa, Team S1-G1, Nance Spring 2018crwdne2935289:0
USFT-NANCE-S18S1G1
crwdns2931471:04crwdne2931471:0
crwdns2935297:012crwdne2935297:0
