crwdns2915892:0crwdne2915892:0
This guide is about how to replace the front camera of Huawei MediaPad M3. A prerequisite of this guide is removing the display. Please see the “Display assembly” guide. The front cameral has 8-mega pixels without a front flash light. The camera is a relatively small part; please store it in a proper place.
crwdns2942213:0crwdne2942213:0
-
-
Use a heat gun to heat the display. It may take up to 30 seconds.
-
Slide in the opening picks to the four corners of the tablet and peel off the display carefully.
-
-
-
Open the display carefully.
-
Use a Phillips #00 screwdriver to remove the two 3.0mm screws.
-
-
-
After removing the two screws, use your hand to take out the silver metal bracket.
-
-
-
-
Use the plastic opening tool to disconnect the two ribbon cable connectors.
-
-
-
Remove the display assembly from the device.
-
-
-
Use a Phillips #00 screwdriver to remove the six 3.0mm screws.
-
-
-
Use your hand to remove the silver metal bracket.
-
-
-
Use your hand to remove the two black plastic covers.
-
-
-
Use a plastic opening tool to remove the front camera.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.