crwdns2915892:0crwdne2915892:0
This guide will show how to access and remove the daughterboard of this device.
crwdns2942213:0crwdne2942213:0
-
-
Insert a SIM opening tool in the hole on the left side and push it in.
-
Remove the SIM card tray.
-
-
-
Switch off your phone.
-
Prepare an iOpener and apply it to the back of the phone for about two minutes to loosen the adhesive beneath the back cover.
-
-
-
Lift up the back cover with a suction cup until you can insert the flat end of a halberd spudger.
-
Use the halberd spudger to cut the adhesive beneath the back cover on all sides of the phone.
-
-
-
-
Flip the back cover over to the side.
-
Remove the Phillips #00 screw which holds down the metal shield, sitting on top of the connection of the fingerprint sensor cable.
-
-
-
Use a pair tweezers to remove the metal shield covering the connector of the fingerprint sensor.
-
Disconnect the fingerprint sensor cable with a spudger.
-
-
-
Unscrew the back cover from the base, then remove black cover.
-
-
-
Unhook black strip over battery at both ends and remove.
-
-
-
Pop out daughterboard and disconnect black and white wires.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
IUPUI, Team 3-5, Harley Spring 2022 crwdns2935289:0IUPUI, Team 3-5, Harley Spring 2022crwdne2935289:0
IUPUI-HARLEY-S22S3G5
crwdns2931471:03crwdne2931471:0
crwdns2935297:06crwdne2935297:0
