crwdns2942213:0crwdne2942213:0
-
-
Place phone on a heating bed.
-
I set it to 80 degrees celcius and left it on there for 5 minutes.
-
-
-
once the glue is softened, use the plastic pick tool to loosen one edge.
-
leave a pick under one side to stop that side from re-sticking as you move onto the next edge.
-
-
-
place the back cover side by side with the rest of he phone. being careful a the fingerprint scanner cable is on the back of the phone
-
take out all the screws in the bottom part of the phone and gently lift off, away from the phone.
-
unclip the ribbon cable.
-
-
-
-
next repeat the same process along the top part. (be careful with the cameras, the cover should just unclip without much effort.)
-
be careful of the 2 screws circled. these need to come out as well.
-
-
-
gently pry the battery terminal away from the board
-
next pull tab 1 and 2 individually.
-
-
-
when you pull tab 3, the battery should hinge away from you and then pull towards you .
-
-
-
insert a new battery and repeat the steps backwards.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
