crwdns2894164:0crwdne2894164:0

crwdns2915892:0crwdne2915892:0

The front bumper needs to be removed to perform maintenance on for instance the radiators, the washer fluid container, the outside temperature sensor, fog lights, daytime running lights (DRLs), or the horn.

If you are replacing your front bumper, don’t forget to install the license plate.

crwdns2860947:0crwdne2860947:0

crwdns2890040:0crwdne2890040:0

  1. Open the hood and unscrew the 10mm bolts located at the top front. Unscrew the screw located at the side top corner under the fender, and repeat on the other side. Unscrew the screw located at the side top corner under the fender, and repeat on the other side.
    • Open the hood and unscrew the 10mm bolts located at the top front.

    • Unscrew the screw located at the side top corner under the fender, and repeat on the other side.

  2. Unscrew 4 screws located underneath the front of the front bumper. With the flathead, unclip the 2 push rivets underneath the side of the front bumper, disconnecting each fender from the bumper. Repeat on the other side.
    • Unscrew 4 screws located underneath the front of the front bumper.

    • With the flathead, unclip the 2 push rivets underneath the side of the front bumper, disconnecting each fender from the bumper.

    • Repeat on the other side.

  3. Gently, pull the side corner loose. Pull from the car and slightly downwards to detach the remaining corner.
    • Gently, pull the side corner loose.

    • Pull from the car and slightly downwards to detach the remaining corner.

    • Repeat on the other side.

  4. If your car has fog lights, this is a good time to unplug those. The bumper is now only attached with 2 clips at the top.
    • If your car has fog lights, this is a good time to unplug those.

    • The bumper is now only attached with 2 clips at the top.

    • Push the front of each clip towards the car and unlatch it.

  5. Hold the bumper in the center and remove it by moving it down and outwards. The bumper wraps around the bottom and fender parts, take care not to damage anything when removing the bumper. Some of the 4 bottom nut clips might move or detach entirely when removing the bumper. Ensure these are at their correct positions.
    • Hold the bumper in the center and remove it by moving it down and outwards.

    • The bumper wraps around the bottom and fender parts, take care not to damage anything when removing the bumper.

    • Some of the 4 bottom nut clips might move or detach entirely when removing the bumper. Ensure these are at their correct positions.

crwdns2915888:0crwdne2915888:0

To reassemble your device, follow these instructions in reverse order.

crwdns2878480:0crwdne2878480:0

knipwim

crwdns2886885:001/09/2018crwdne2886885:0

6,475 crwdns2915208:0crwdne2915208:0

crwdns2886889:028crwdne2886889:0

crwdns2917036:00crwdne2917036:0

crwdns2917038:0crwdne2917038:0

crwdns2894754:0crwdne2894754:0:

crwdns2894766:024crwdne2894766:0 6

crwdns2894768:07crwdne2894768:0 62

crwdns2894768:030crwdne2894768:0 189

crwdns2894770:0crwdne2894770:0 1,383