How to fix jumpy scroll wheel of a computer mouse
crwdns2944109:0crwdnd2944109:0Jithu Mohancrwdnd2944109:0crwdnd2944109:0crwdnd2944109:0crwdne2944109:0
crwdns2944111:0September 22, 2024crwdne2944111:0
crwdns2915892:0crwdne2915892:0
crwdns2942287:0crwdne2942287:0This easy hack will save you from buying a new mouse if your scroll wheel is acting up and is not functioning properly causing you a terrible scrolling experience.
The cause of this issue is, the inner plate holding the rotating mechanism has become loose due to wear and time
crwdns2942213:0crwdne2942213:0
crwdns2943215:0crwdne2943215:0
crwdns2944105:0crwdne2944105:0
-
-
Flip the mouse upside down and remove the screw on the bottom of the mouse casing using a screwdriver
-
-
-
Remove the wire from the board by slowly pulling the connector
-
-
-
1)Remove the board out of the case
-
2)Slowly pull out the scroll wheel out of the encoder wheel well
-
-
-
Slowly remove the metallic clamps from the plastic body to free the plastic case, holding the rotating mechanism .(If possible remover the metallic case fully from underneath the board, if it is not soldered)
-
Pull back or bend the plastic case a little bit for easy insertion of spring
-
Place a small coil spring on the extreme end of the small metallic plate holding the rotating mechanism against the plastic body
-
Pull the other end of the coil and place it on the other end where the scroll wheel is inserted
-
This will ensure that the small metallic plate and rotating mechanism are not loose thereby not causing a jumpy scroll wheel
-
-
-
Now put this entire contraption inside the metallic case and close the metallic clamps
-
Inserted the scroll wheel into the wheel well and close up the mouse
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2947410:01crwdne2947410:0
quel est la taille du resort qu'on doit acheter pour la réparation
