crwdns2942213:0crwdne2942213:0
-
-
Prepare Tools and replacement parts.
-
-
-
Grab wegdge with tweezers
-
Loosen the screw. (while holding the wedge)
-
-
-
Put the wedge in the tranducer from below.
-
Correct Placement. Tool is flush with transducer.
-
Incorrect Placement. tool is too high.
-
-
-
-
Fasten the screw lightly
-
Tighten the screw just so the wedge does not slip out of the tranducer.
-
-
-
Place gauge below Tool
-
Loosen the screw so the wedge slides onto the gauge Lever.
-
Lift the gauge up until in contact with the transducer horn.
-
Now the Tool-Top should be flush with the Transducer-Horn
-
Tighten the screw with the torque- wrench
-
-
-
Use tweezers to push the wire down the wire hole, until it Ends some cm below the tool wedge.
-
Use scissors to cut the (contaminated) Wire down to a length of about 1cm below wedge end.
-
-
-
Use tweezers to thread the wire through the hole at the end of the wedge.
-
Afet threading pull the wire some cm through the hole.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
