crwdns2915892:0crwdne2915892:0
Reshaping the contact point electrodes which hold bObi's dustbin in place can resolve installation and bin latching difficulties.
crwdns2942213:0crwdne2942213:0
-
-
Remove bObi's dustbin:
-
Push down on the button found on bObi's back to release the dustbin.
-
-
-
-
Inside bObi are two contact point electrodes, secured with a small red fastener and two screws.
-
Use a screwdriver to reach underneath the electrodes and pull upward gently to bend them back to the correct shape.
-
-
-
When the electrodes are fixed, slide the dustbin back into bObi. The HEPA filter side of the dustbin should face down.
-
Ensure it locks in place, and the contact point electrodes will line up correctly, so bObi can resume functioning.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
