crwdns2915892:0crwdne2915892:0
Is your Schlage Connect not working? You may need to reset the device to factory settings. Can't find the user guide for instructions? This guide will help you!
Device model: Schlage Connect BE469IR
Why this guide? This guide provides easy-to-follow steps to reset your device. No user guide is required.
What does this guide provide? Twelve quick steps to reset the device to factory settings without a user guide.
Note: Before resetting the device, you will need your device's original factory's preset user code. You can find this code either in the device's user guide or on the back of the device's inside cover. Steps 3-6 will show you how to do this without the user guide.
Need Additional Resources? Go to Schlage's YouTube Channel.
crwdns2942213:0crwdne2942213:0
-
-
Ensure the latch is retracted (not locked).
-
-
-
Remove the battery cover by sliding the cover upwards.
-
-
-
Using a Phillips #0 screwdriver, remove the bottom screw and top screw.
-
-
-
Carefully remove the device from the door.
-
-
-
-
Locate the programming code behind the alarm device.
-
-
-
Reattach the alarm device to the door by screwing the bottom and top screws.
-
-
-
Discharge residual electricity by pressing the exterior Schlage button three times on the keypad.
-
-
-
Press the Schlage button and continue pressing while at the same time reconnecting the battery.
-
-
-
Release the button and reattach the battery cover.
-
-
-
Complete the reset procedure by pressing the Schlage button one time.
-
-
-
Enter the original factory's preset user code on the keypad.
-
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0