crwdns2915892:0crwdne2915892:0
After lots of use or spills, the controls on your RumblePad2 may become sticky and unresponsive. This will guide you through the process of cleaning the controller and fix this issue.
crwdns2942213:0crwdne2942213:0
-
-
-
Remove the battery pack cover.
-
Remove the batteries.
crwdns2952109:0crwdne2952109:0
-
-
-
Remove the five screws from the back of the controller using the #0 Phillips screwdriver.
-
-
-
Remove the back panel from the controller.
-
-
-
-
Remove the two screws from the motherboard using the #0 Phillips screwdriver.
-
-
-
Remove the rumble motors from their slots and allow them to hang freely.
-
Remove the motherboard from the controller by lifting up.
-
-
-
Wipe the outer face of the analog sticks with a wet cotton swab or paper towel.
-
-
-
Wipe the button pads with a wet cotton swab or paper towel.
-
-
-
Remove the buttons from their slots by pushing them in from the front.
-
Wipe the buttons with a wet cotton swab or paper towel
-
-
After allowing the controller time to dry, reassemble your device by following these instructions in reverse order.
crwdns2935287:0crwdne2935287:0
Michigan Tech, Team S3-G11, Galliah Fall 2017 crwdns2935289:0Michigan Tech, Team S3-G11, Galliah Fall 2017crwdne2935289:0
MTU-GALLIAH-F17S3G11
crwdns2934841:01crwdne2934841:0
crwdns2935297:012crwdne2935297:0
