Hover-1 Matrix LED Replacement
crwdns2959932:0crwdnd2959932:0Jici Zhuangcrwdnd2959932:0crwdnd2959932:0crwdnd2959932:05crwdnd2959932:0crwdne2959932:0
crwdns2959936:0N'w 16, 2021crwdne2959936:0
crwdns2869540:0crwdne2869540:0: 721
crwdns2959988:0crwdne2959988:0
- crwdns2959990:0crwdne2959990:0
- 0
- crwdns2959992:0crwdne2959992:0
- 8
- crwdns2959994:0crwdne2959994:0
- 66
- crwdns2959996:0crwdne2959996:0
- 721
crwdns2955950:0crwdne2955950:0: 0
crwdns2959998:0crwdne2959998:0
crwdns2960000:0crwdne2960000:0crwdns2959984:0crwdne2959984:0: 0 1
crwdns2959956:0crwdne2959956:0
crwdns2959968:01crwdne2959968:0
crwdns2959986:0crwdne2959986:0: 0 1
crwdns2959958:0crwdne2959958:0
crwdns2959976:01crwdne2959976:0
crwdns2862611:0crwdne2862611:0
crwdns2862612:0crwdne2862612:0
crwdns2915892:0crwdne2915892:0
crwdns2959928:0crwdne2959928:0 ↓When the Hover-1 Matrix is turned on, the LED light in the board will glow to show you that it is on. It is an important part of the hoverboard because it lights up the path in front of you. If you have a broken LED it could lead to injuries.
If you have already tried other troubleshooting methods, and have not found a solution, this guide will teach you how to replace the LED light in your Hover-1 Matrix.
crwdns2959930:0crwdne2959930:0
crwdns2943215:0crwdne2943215:0
-
-
-
Flip the board over to remove the screws from the back panel using a Phillips #1 screwdriver.
crwdns2952109:0crwdne2952109:0
-
-
-
Remove the screws on the metal layer inside using the Phillips #0 screwdriver.
-
-
-
Separate the upper shell from the metal layer inside.
-
-
-
-
Remove the two screws from the circuit board.
-
Remove the circuit board and LED light.
-
-
To reassemble your device, follow these instructions in reverse order.
crwdns2935287:0crwdne2935287:0
UC Davis, Team S7-G2, Lore Fall 2018 crwdns2935289:0UC Davis, Team S7-G2, Lore Fall 2018crwdne2935289:0
UCD-LORE-F18S7G2
crwdns2931471:03crwdne2931471:0
crwdns2935297:048crwdne2935297:0
