crwdns2915892:0crwdne2915892:0
In order for your Hover-1 Coast to be used for its intended purpose you must have a functioning battery. This procedure is fairly easy to accomplish and key to using the board to its full potential.
crwdns2942213:0crwdne2942213:0
-
-
To remove the battery on the Hover-1 Coast, you must uncover the screws on the top of the board.
-
Using a pick tool, puncture the grip tape and expose the screws.
-
Loosen all four 1" screws using a Phillips #1 screwdriver.
-
-
-
Now pull the black protective cover off the board.
-
Locate the battery.
-
-
-
-
The battery is connected by these two sets of wires.
-
Remove the yellow wire first by pulling the two wires gently in opposite directions.
-
Now pull apart the black wire by gently pulling the two wires in opposite directions.
-
-
-
Once the battery has been disconnected, gently pry the battery upward.
-
Once the battery is freed, remove it with your hands.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0
crwdns2947410:01crwdne2947410:0
Where can you order a replacement battery?