crwdns2915892:0crwdne2915892:0
Below we have outlined a few issues that we plan to address based on the research that we have conducted.
• Heating coil burn out
• Temperature control switch burn out
• On/Off switch burn out
crwdns2942213:0crwdne2942213:0
-
-
Ensure that you have a clean work station, and that you can easily keep track of small, loose parts.
-
In addition, MAKE SURE IT IS UNPLUGGED FOR ALL FOLLOWING STEPS!
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Firmly grasp the end of the Iron with the black plastic cap on the heating element end.
-
With your free hand, use tweezers to firmly grasp the small retaining ring sitting between the heating element and the handle body.
-
Once you have a firm grasp, pull up on the retaining ring, and it should come loose.
-
-
-
With the ring loose, turn the handle body over, and you will see three screw holes.
-
Take a PH1 screwdriver, and loosen up all three 6mm Phillips #1 screws in the handle body.
-
-
-
-
Once the screws have been removed, set them aside and with a pry tool, firmly pull the handle body apart in half lengthwise.
-
-
-
For removing the clamping mechanism, firmly grasp the iron in your hand by the handle body, and locate the screw as shown in the picture.
-
Remove the screw shown (8mm Phillips #2 Pan Head) and when finished do the same for the opposite side.
-
-
-
Once both screws have been removed, continue to remove the top clamping half of the mechanism from the body of the Iron.
-
-
-
Rotate the handle, and remove the screw that holds on the spring mechanism for the clamp. This screw is a 8mm Phillips #2 Pan Head.
-
Once this step is fished your Hot Tools Professional 1110 will be fully disassembled and ready to have its components replaced.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
IUPUI, Team S2-G2, Wilson Fall 2017 crwdns2935289:0IUPUI, Team S2-G2, Wilson Fall 2017crwdne2935289:0
IUPUI-WILSON-F17S2G2
crwdns2931471:04crwdne2931471:0
crwdns2935297:05crwdne2935297:0
crwdns2947412:03crwdne2947412:0
How can I tighten the clamp?
where can i get or order the part for the (spring with small roller)
i have a model ht1110xl hot tools iron
What is the c/b that acts as the on/off switch? It was improperly shrink wrapped causing it to burn through and break the switch
