crwdns2915892:0crwdne2915892:0
This guide will walk you through the steps to remove your rotation motor. Though disassembly is simple, it is a difficult process to put back together because you have to solder wires or use a wire connector to reattach a new rotation motor.
crwdns2942213:0crwdne2942213:0
-
-
Lay fan on the ground and use your fingers peel the three feet off the bottom of the fan.
-
-
-
Remove the three 12mm screws using the Phillips #0 Screwdriver.
-
-
-
-
Remove the two 10mm screws using the Phillips #0 Screwdriver.
-
-
-
Move the rotation motor left and right to reveal the screw connecting it to the fan.
-
Remove the 18mm screw from the side of the motor using the Phillips #0 Screwdriver.
-
-
-
Using the wire cutters, severe the wires connecting the rotation motor to the fan.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 10-40, Amido Fall 2014 crwdns2935289:0Cal Poly, Team 10-40, Amido Fall 2014crwdne2935289:0
CPSU-AMIDO-F14S10G40
crwdns2931471:03crwdne2931471:0
crwdns2935297:07crwdne2935297:0
crwdns2944067:02crwdne2944067:0
It seems that these instructions are on “How to eeplacr the oscillation motor". But they neglect the requirement to have a replacement motor or how/where to get the replacement motor. Otherwise the steps seem clear.
