crwdns2915892:0crwdne2915892:0
Use this guide to replace the throttle cable in a Honda Light Duty Tiller F220K1AT715492.
crwdns2942213:0crwdne2942213:0
-
-
Pull the spark plug connector straight off of the spark plug.
-
-
-
Push down on the two tabs at the top of the air filter cover.
-
With the two tabs depressed, swing the top of the cover down.
-
Remove the cover.
-
-
-
Pull the air filter out of the housing and remove it.
-
-
-
Use an 8 mm socket to remove the following fasteners securing the air cleaner housing:
-
Two silver nuts
-
One black bolt
-
-
-
Slide the pink breather tube out of its clip on the back of the air cleaner housing.
-
-
-
-
Use a flathead screwdriver to gently pry the black breather tube off of its connector on the back of the air cleaner housing.
-
-
-
Hold the black carburetor hose in place and rotate the air cleaner housing clockwise until you can slide the hose out of its slot on the air cleaner housing.
-
Remove the air cleaner housing.
-
-
-
Use an 8 mm wrench to hold the throttle cable barrel adjuster in place while you use a 10 mm wrench to loosen the lock nut.
-
Continue to loosen the lock nut until it is against the end of the threads.
-
With the lock nut against the end of the threads, tighten the barrel until it is against the lock nut to add as much slack as possible to the cable.
-
-
-
Lift the throttle cable straight up and slide it through the slot on the throttle control.
-
-
-
Slide the throttle cable housing out of its slot on the engine case.
-
-
-
Remove any zip-ties securing the throttle cable.
-
-
-
Use a Phillips #2 screwdriver to remove the screw securing the throttle lever cover.
-
-
-
Remove the throttle lever cover.
-
Lift the throttle cable out of the throttle lever cover.
-
-
-
Slide the small clip securing the throttle cable housing out of its slot in the throttle lever.
-
-
-
Slide the throttle cable housing out of the throttle lever.
-
Remove the throttle cable.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
