crwdns2915892:0crwdne2915892:0
This guide shows how to remove the outer covers for the Honda EU2200IT generator. This is necessary in order to access many internal parts of the generator.
crwdns2942213:0crwdne2942213:0
-
-
Lift and remove the spark plug cover.
-
-
-
Grab the plastic housing at the end of the spark plug wire.
-
Pull firmly to disconnect the wire from the spark plug.
-
-
-
Use a Phillips #2 screwdriver to loosen the screw holding the maintenance cover in place.
-
-
-
Swing the top of the maintenance cover out.
-
Remove the maintenance cover.
-
-
-
Remove the four Phillips screws securing the back cover.
-
-
-
-
Remove the four screws securing the front cover:
-
Two Phillips screws
-
Two Phillips screws (one on each side)
-
-
-
Swing the top edge of the front cover away from the generator.
-
Pull the front cover away slightly away.
-
-
-
Remove the lower gray plates from both sides of the generator.
-
-
-
Remove the fasteners securing the left (non-access) cover:
-
Two Phillips screws
-
Two 10 mm bolts
-
-
-
Slide the vent and drain tubes out of their cover ports along the bottom of the right cover.
-
-
-
Remove the Phillips screw securing the starter rope port.
-
-
-
Thread the starter rope handle through the port's cutout.
-
-
-
Remove the right (access-side) cover.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
